Installing Components; Installing The Sfp Transceiver In The Ln2600 Router - Juniper LN2600 Manual

Rugged security router

Hide thumbs Also See for LN2600:

Table of Contents

CHAPTER 10

Installing Components

Installing the SFP Transceiver in the LN2600 Router on page 51

Weatherproofing the LN2600 Router on page 53

You can install up to eight SFP transceivers in the LN2600 router. The SFP transceivers

are hot-removable and hot-insertable. You can remove and replace them without

powering off the LN2600 router or disrupting the router functions.

WARNING:

Do not look directly into transceivers or into the ends of fiber-optic

cables connected to a transceiver. Fiber-optic transceivers emit laser light

that can damage your eyes.

CAUTION:

When handling fiber-optic transceivers and fiber-optic cable, observe the

following precautions:

Do not leave a fiber-optic transceiver uncovered except when inserting or

removing cable. The safety cap keeps the port clean and prevents

accidental exposure to laser light.

Do not bend fiber-optic cable beyond its minimum bend radius. An arc

smaller than a few inches in diameter can damage the cable and cause

problems that are difficult to diagnose.

Do not let fiber-optic cable hang free from the connector. Do not allow

fastened loops of cable to dangle, which stresses the cable at the fastening

point.

Table of Contents