Copying The Active Ivr Service Group Database; Clearing Ivr Service Group Database; Verifying Ivr Service Group Configuration - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 23 Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 4
switch(config-ivr-sg)# exit
switch(config)#
Step 5
switch(config)# ivr service-group activate
switch(config)# ivr service-group activate
default-sg-deny
switch(config)# no ivr service-group activate
Step 6
switch(config)# ivr vsan-topology activate
Step 7
switch(config)# ivr distribute
Step 8
switch(config)# ivr commit

Copying the Active IVR Service Group Database

You cannot modify the active IVR service group database. However, you can modify the configured IVR
service group database. To copy the active IVR service group database to the manually configure service
group database, use the following command in EXEC mode:
switch# ivr copy active-service-group user-configured-service-group

Clearing IVR Service Group Database

You can clear all entries in the IVR service group database using the clear ivr service-group database
command in EXEC mode. This command only clears the configured database, not the active database.
switch# clear ivr service-group database

Verifying IVR Service Group Configuration

Use the show ivr service-group active command to view the active IVR service group database.
switch# show ivr service-group active
IVR ACTIVE Service Group
====================================
SG-ID
------------------------------------------------------------------------------
1
OL-18084-01, Cisco MDS NX-OS Release 4.x
SG-NAME AFID VSANS
IVR-SG1 10 1-2,6-10
Purpose
Returns to configuration mode.
Activates the service group configuration and
sets the communication policy between
switches in the default service group as allow
(default).
Activates the service group configuration and
sets the communication policy between
switches in the default service group to deny.
To change the communication policy
Note
back to allow, you must issue the ivr
service-group activate command
again.
Deactivates (default) the service group
configuration.
Activates the VSAN topology.
Enables CFS distribution for the IVR
configuration.
Commits the IVR configuration to the fabric.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring IVR
23-15