Huawei NetEngine80E Configuration Manual - Reliability page 1201

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
l
l
----End
Example
After completing L2TP two-node hot backup configurations, run the display remote-backup-
profile command. If the following information is displayed, the preceding configurations are
successful:
l
<HUAWEI> display remote-backup-profile profile1
-----------------------------------------------
Profile-Index
Profile-Name
Service
Remote-backup-service : s1
Backup-ID
track protocol
VRRP-ID
VRRP-Interface
Interface
State
Peer State
Backup mode
Slot-Number
Card-Number
Port-Number
Traffic threshold
Traffic interval
[HUAWEI] display l2tp tunnel rui
LTID: local assigned tunnel ID , RTID:Remote assigned tunnel ID
RA:Remote Ip address, RN: Remote Name; RG: Register(L:local,R:remote)
Basic Info
------------------------------------------------------------------------------
LTID
------------------------------------------------------------------------------
7
------------------------------------------------------------------------------
Total 1, printed 1
[HUAWEI] display l2tp session rui
LTID: local assigned tunnel ID , RTID: Remote assigned tunnel ID
LSID: local assigned session ID , RSID: Remote assigned session ID
RG: Register(L:local,R:remote), FWS: Fowarding state(L:local interface, P:protect
path).
Issue 02 (2014-09-30)
Run the display l2tp tunnel rui [ tunnel-item tunnel-id | tunnel-name remote-name | bas-
interface { interface-name | interface-type interface-number } | remote-backup-profile
profile-name | remote-backup-service service-name ] command to check L2TP tunnel
backup information.
Run the display l2tp session rui [ session-item session-id | source-ip source-ip-address |
destination-ip destination-ip-address | bas-interface { interface-name | interface-type
interface-number } | remote-backup-profile profile-name | remote-backup-service
service-name ] command to check L2TP session backup information.
Run the display l2tp statistics rui [ verbose ] command to check L2TP tunnel backup
statistics.
Run the display l2tp lac abnormal-rui-users command to check information about users
that have abnormal online status on a device enabled with L2TP two-node hot backup.
Run the display access-user domain command to display information about the access
users in a specified domain.
The value of the Service field is bras l2tp.
: 0x800
: profile1
: bras l2tp
: 10
: VRRP
: 1
: Eth-Trunk1.2
:
Eth-Trunk1.1
: Master
: Slave
: hot
: --
: --
: --
RTID RA
86 3.3.3.3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: --
: 1(minutes)
RN
HUA-241
11 Multi-node Backup Configuration
Redundant info
Sessions RG state
1 L active
Life(s)
14s
1184