Link Aggregation Commands - Panasonic ZEQUO 6400 Operating Instructions Manual

45.Link Aggregation Commands

Link aggregation is a technology to connect two Switching Hubs with
multiple ports and bundle them as one port. This provides path
redundancy and enhanced bandwidth.
You can select how to distribute communications to bundled ports
from several methods.
To use the LACP protocol, which automatically configures and monitors
link aggregation, enable the use of LACP in this chapter and configure the
protocol settings by referring to "LACP Configuration Commands."
create link_aggregation group_id <value 1-48> {type [lacp | static]}
delete link_aggregation group_id <value 1-48>
config link_aggregation group_id <value 1-48> {master_port <port> | ports <portlist> | state
[enable | disable]} (1)
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest | l4_src_port | l4_dest_port | l4_src_dest_port]
show link_aggregation {group_id <value 1-48> | algorithm}
45.1. create link_aggregation group_id
 Description
This command is used to create a link aggregation group.
 Format
create link_aggregation group_id <value 1-48> {type [lacp | static]}
Figure 45-1 Link aggregation overview
491
45. Link Aggregation Commands