Ospfv3 Commands - Panasonic ZEQUO 6400 Operating Instructions Manual

60. OSPFv3 Commands

60.OSPFv3 Commands
OSPFv3 is an OSPF protocol for IPv6. It has almost the same functions as
OSPF for IPv4 does.
OSPF and OSPFv3 can be used simultaneously.
enable ospfv3
disable ospfv3
show ospfv3 {[ipif <ipif_name 12> | all]}
config ospfv3 router_id <ipaddr>
create ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
delete ospfv3 area <area_id>
config ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
show ospfv3 area {<area_id>}
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
delete ospfv3 aggregation <area_id> <ipv6networkaddr>
config ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
show ospfv3 aggregation {<area_id>}
show ospfv3 lsdb {area <area_id> | type [rtrlink | netlink | inter_area_prefix | inter_area_router |
asextlink | link_lsa | intra_area_prefix]}
show ospfv3 neighbor {<neighbor_id> ipif <ipif_name 12>}
show ospfv3 virtual_neighbor {<area_id> <neighbor_id>}
config ospfv3 [ipif <ipif_name 12> | all] {area <area_id> | priority <value 0-255> | hello_interval
<sec 1-65535> | dead_interval <sec 1-65535> | instance <value 0-255> | metric <value 1-
65535>| state [enable | disable] | passive [enable | disable]}
create ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval
<sec 1-65535> | instance <value 0-255>}
config ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval
<sec 1-65535> | instance <value 0-255>}
delete ospfv3 virtual_link <area_id> <neighbor_id>
show ospfv3 virtual_link {<area_id> <neighbor_id>}
60.1. enable ospfv3
 Description
This command is used to enable OSPFv3 on the Switch.
 Format
enable ospfv3
 Parameters
None.
672