Debug Buffer - Panasonic ZEQUO 6400 Operating Instructions Manual

20. Debug Software Command List

20.2. debug buffer

 Description
Use this command to show the debug buffer's state, or dump, clear, or upload the debug
buffer to a TFTP server.
When selecting to output to the debug buffer and there are debug messages
being outputted, the system memory pool will be used as the debug buffer.
The functions which will use the system memory pool resource may fail to
execute command such as download and upload firmware, or save
configuration. If you want to execute these commands successfully, please
use the command "debug buffer clear" to release the system's memory pool
resources manually first.
 Format
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
 Parameters
utilization
Display the debug buffer's state.
dump Display the debug message in the debug buffer.
clear Clear the debug buffer.
upload_toTFTP
Upload the debug buffer to a TFTP server specified by IP address.
<ipaddr>
Specifies the IPv4 address of the TFTP server.
<path_filename 64>
The pathname specifies the DOS pathname on the TFTP server. It can be a relative
pathname or an absolute pathname. This value can be up to 64 characters long.
 Restrictions
Only Administrator-level users can issue this command.
 Example
To show the debug buffer's state:
Zxxx0:admin# debug buffer utilization
Command: debug buffer utilization
Allocate from
Total size
Utilization rate
Zxxx0:admin#
: System memory
: 2 MB
: 30%
222