Panasonic ZEQUO 6400 Operating Instructions Manual page 464

other_config_flag
Specify to enable or disable the function.
enable
When set to enable, it indicates that hosts receiving this RA must use a stateful
address configuration protocol to obtain on-address configuration information.
disable
Set to disable to stop hosts receiving this RA from using a stateful address
configuration protocol to obtain on-address configuration information.
min_rtr_adv_interval
Specify the minimum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 3 seconds and no
greater than .75 * MaxRtrAdvInterval. The default is 0.33 * MaxRtrAdvInterval.
<sec 3-1350>
Specify the time between 3 and 1350 seconds.
max_rtr_adv_interval
Specify the maximum time allowed between sending unsolicited multicast Router
Advertisements from the interface, in seconds. It must be no less than 4 seconds and no
greater than 1800 seconds. The default is 600 seconds.
<sec 4-1800>
Specify the time between 4 and 1800 seconds.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the RA state as enabled and the life_time of the "tiberius" interface to be
1000 seconds:
Zxxx0:admin#config ipv6 nd ra ipif tiberius state enable life_time 1000
Command: config ipv6 nd ra ipif tiberius state enable life_time 1000
Success.
Zxxx0:admin#
40.6. config ipv6 nd ra prefix_option ipif
 Description
This command is used to configure the prefix option for the router advertisement
function.
 Format
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr>
{preferred_life_time <sec 0-4294967295> | valid_life_time <sec 0-4294967295> |
on_link_flag [enable | disable] | autonomous_flag [enable | disable]}(1)
40. IPv6 NDP Commands
465