59. Open Shortest Path First (OSPF) Command List
59.14. config ospf router_id
Description
The command is used to configure the router ID for the Switching Hub. Each Switching
Hub that is configured to run OSPF must have a unique router ID.
Format
config ospf router_id <ipaddr>
Parameters
<ipaddr>Enter the router's IP address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the router ID for the Switching Hub:
Zxxx0:admin# config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
Zxxx0:admin#
59.15. create ospf virtual_link
Description
This command is used to create an OSPF virtual link.
Format
create ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple <password 8>]}(1)
Parameters
<area_id>Specifies a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
660