Panasonic ZEQUO 6400 Operating Instructions Manual page 298

 Parameters
<pool_name 12>
Specify the DHCP pool name.
<ipaddr>(Optional) Specify the IP address of the next server.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the next server:
Zxxx0:admin#config dhcp pool next_server engineering 192.168.0.1
Command: config dhcp pool next_server engineering 192.168.0.1
Success.
Zxxx0:admin#
23.15. config dhcp ping_packets
 Description
This command is used to specify the number of ping packets the DHCP server sends to an
IP address before assigning this address to a requesting client.
By default, the DHCP server pings a pool address twice before assigning the address to a
DHCP client. If the ping is unanswered, the DHCP server assumes (with a high probability)
that the address is not in use and assigns the address to the requesting client. If the ping is
answered, the server will discard the current IP address and try another IP address.
 Format
config dhcp ping_packets <number 0-10>
 Parameters
<number 0-10>
Specify the number of ping packets. 0 means there is no ping test. The default value is 2.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure ping packets:
23. DHCP Server Commands
299