Debug Stp Show Counter {Ports [<Portlist> | All] - Panasonic ZEQUO 6400 Operating Instructions Manual

20. Debug Software Command List
20.9. debug stp show counter
 Description
This command used to display the STP counters.
 Format
debug stp show counter {ports [<portlist> | all]}
 Parameters
ports (Optional) Specifies the STP ports for display.
<portlist>
Enter the list of port used for this configuration here.
all Display all port's counters.
If no parameter is specified, display the global counters.
 Restrictions
Only Administrator-level users can issue this command.
 Example
To show the STP counters for port 9:
Zxxx0:admin# debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive:
Total STP Packets
Configuration BPDU
TCN BPDU
RSTP TC-Flag
RST BPDU
Discard:
Total Discarded BPDU
Global STP Disabled
Port STP Disabled
Invalid Packet Format
Invalid Protocol
Configuration BPDU Length
TCN BPDU Length
RST BPDU Length
Invalid Type
Invalid Timers
Zxxx0:admin#
Transmit:
:32 Total STP Packets
:0 Configuration BPDU
:0 TCN BPDU
:15 RSTP TC-Flag
:32 RST BPDU
:0
:0
:0
:0
:0
:0
:0
:0
:0
:0
228
:32
:0
:0
:7
:32