74. Spanning Tree Protocol (STP) commands
74.11. config stp version
Description
This command is used to enable STP globally. If the version is configured as STP or
RSTP, all currently running MSTIs should be disabled. If the version is configured as
MSTP, the current chip design is enabled for all available MSTIs (assuming that CIST is
enabled).
Format
config stp version [mstp | rstp | stp]
Parameters
mstp
Specify to use Multiple Spanning Tree Protocol.
rstp
Specify to use Rapid Spanning Tree Protocol. This is the default.
stp
Specify to use Spanning Tree Protocol.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the STP version:
Zxxx0:admin#config stp version mstp
Command: config stp version mstp
Success.
Zxxx0:admin#
870