Panasonic ZEQUO 6400 Operating Instructions Manual page 295

23. DHCP Server Commands
Zxxx0:admin#config dhcp pool netbios_node_type knicks hybrid
Command: config dhcp pool netbios_node_type knicks hybrid
Success.
Zxxx0:admin#
23.11. config dhcp pool default_router
 Description
This command is used to specify the IP address of the default router for a DHCP client. Up
to three IP addresses can be specified on one command line.
After a DHCP client has booted, the client begins sending packets to its default router. The
IP address of the default router should be on the same subnet as the client. If the default
router is not specified, the default router information will not be provided to the client. If
this command is input twice for the same pool, the second command will overwrite the
first command. The default router must be within the range the network defined for the
DHCP pool.
 Format
config dhcp pool default_router <pool_name 12> {<ipaddr>} {<ipaddr>} {<ipaddr>}
 Parameters
<pool_name 12>
Specify the DHCP pool name.
<ipaddr>(Optional) Specify the IP address of the default router. Up to three IP addresses can be
specified on one command line.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the default router:
Zxxx0:admin#config dhcp pool default_router nyknicks 10.10.10.1
Command: config dhcp pool default_router nyknicks 10.10.10.1
Success.
Zxxx0:admin#
296