Panasonic ZEQUO 6400 Operating Instructions Manual page 269

22. DHCP Relay Commands
22.1. config dhcp_relay
 Description
This command is used to configure the DHCP relay feature of the Switching Hub.
 Format
config dhcp_relay {hops <int 1-16> | time <sec 0-65535>}(1)
 Parameters
hops Specify the maximum number of router hops that the DHCP/BOOTP packets can cross.
The range is 1 to 16. The default value is 4.
<int 1-16>
Specify the maximum number of router hops that the DHCP/BOOTP packets can
cross. The maximum number of hops value must be between 1 and 16.
time Specify the minimum time in seconds within which the Switching Hub must relay the
DHCP/BOOTP request. If this time is larger than the DHCP packet's time, the Switching
Hub will drop the DHCP/BOOTP packet. The range is 0 to 65535. The default value is 0.
<sec 0-65535>
Specify the minimum time in seconds within which the Switching Hub must relay
the DHCP/BOOTP request. The minimum time value must be between 0 and
65535 seconds.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the DHCP relay:
Zxxx0:admin#config dhcp_relay hops 4 time 2
Command: config dhcp_relay hops 4 time 2
Success.
Zxxx0:admin#
270