Link Aggregation - Panasonic GA-ML Series Manual

5.5

Link Aggregation

Use the following window to implement the settings on a link aggregation
and display its settings.
Choose L2 Features > Link Aggregation to display the following
window.
In the first section, you can configure the following parameters.
System Priority
Load Balance
Algorithm
Click Apply to reflect the change.
In the section of Channel Group Information, you can configure the
following parameters.
From Port/ To Port
Figure 5-40 Link Aggregation
Parameter
Enter the value of a system priority to use. The range is
from 1 to 65,535. By default, the value is set to 32,768.
The system priority determines the port, which enables
a port to participate in a port-channel and to become
the standalone mode. The lower the value, the higher
priority will be. If there are two or more ports with the
same priority, the priority is determined depending on
the port-number.
Choose a load balance algorithm to use. The value to
choose are Source MAC, Destination MAC, Source
Destination MAC, Source IP, Destination IP, Source
Destination IP, Source L4 Port, Destination L4 Port
and Source Destination L4 Port. By default, this
option is set to Source Destination MAC.
Parameter
Choose the port you use.
5 L2 Features
5.5 Link Aggregation
Overview
Overview
129