Table of Contents
Advertisement
60. OSPFv3 Commands
state
(Optional) Specifies to enable or disable this interface to run OSPFv3.
enable
Specifies that the OSPFv3 state, for this interface, will be enabled.
disable
Specifies that the OSPFv3 state, for this interface, will be disabled.
passive (Optional) Specifies that the user may select Active or Passive for this OSPFv3 interface.
Active interfaces actively advertise OSPFv3 to routers on other Intranets that are not part
of this specific OSPFv3 group. Passive interfaces will not advertise to any other routers
than those within its OSPFv3 intranet. When this field is disabled, it denotes an active
interface.
enable
Specifies that the passive state will be enabled.
disable
Specifies that the passive state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an OSPFv3 interface:
Zxxx0:admin# config ospfv3 ipif System area 0.0.0.0 priority 100 hello_interval 20
dead_interval 60 instance 1 metric 20 state enable passive disable
Command: config ospfv3 ipif System area 0.0.0.0 priority 100 hello_interval 20
dead_interval 60 instance 1 metric 20 state enable passive disable
Success.
Zxxx0:admin#
690
Advertisement
Chapters
Table of Contents
