Panasonic ZEQUO 6400 Operating Instructions Manual page 317

25. DHCPv6 Relay Command List
25.5. config dhcpv6_relay ipif
 Description
The command is used to configure the DHCPv6 relay state of one specific interface or
all interfaces.
 Format
config dhcpv6_relay ipif [<ipif_name 12> | all] state [enable | disable]
 Parameters
ipif Specifies the name of the IP interface.
<ipif_name 12>
Enter the IP interface name used here. This name can be up to 12 characters long.
all Specifies that all the configured IP interfaces wil be used.
state Specifies if the DHCPv6 relay state will be enabled or disabled.
enable
Choose this parameter to enable the DHCPv6 relay state of the interface.
disable
Choose this parameter to disable the DHCPv6 relay state of the interface.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the DHCPv6 relay state of the System interface to enable:
Zxxx0:admin# config dhcpv6_relay ipif System state enable
Command: config dhcpv6_relay ipif System state enable
Success.
Zxxx0:admin#
318