Panasonic ZEQUO 6400 Operating Instructions Manual page 488

44.8. config max_mcast_group
 Description
This command is used to configure the maximum number of multicast groups a port
or VLAN can join. If the IPv4 or IPv6 option is not specified, IPv4 is implied. When the
joined groups for a port or a VLAN have reached the maximum number, the newly
learned group will be dropped if the action is specified as drop. The newly learned
group will replace the oldest group if the action is specified as replace.
 Format
config max_mcast_group [ports <portlist> | vlanid <vlanid_list>] {[ipv4 | ipv6]}
{max_group [<value 1-1024> | infinite] | action [drop | replace]} (1)
 Parameters
ports Specify a range of ports to configure the maximum multicast group.
<portlist>
Specify a range of ports to be configured.
vlanid Specify the VLAN ID to configure the maximum multicast group.
<vlanid_list>
Enter the VLAN ID of the VLAN here.
ipv4 (Optional) Specify that the maximum number of IPv4 learned addresses should be
limited.
ipv6 (Optional) Specify that the maximum number of IPv6 learned addresses should be
limited.
max_group
(Optional) Specify the maximum number of the multicast groups.
<value 1-1024>
The range is from 1 to 1024 or infinite.
infinite
Infinite is the default setting.
action (Optional) Specify the action for handling newly learned groups when the register is full.
drop The new group will be dropped.
replace
The new group will replace the oldest group in the register table.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the maximum number of multicast groups that ports 1 and 3 can join to
100:
44. Limited Multicast IP Address Commands
489