Panasonic ZEQUO 6400 Operating Instructions Manual page 702

config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]}
create pim crp group <network_address> rp <ipif_name 12>
delete pim crp group <network_address>
show pim crp
config pim last_hop_spt_switchover [never | immediately]
show pim ipmroute
create pim static_rp group <network_address> rp <ipaddr>
delete pim static_rp group <network_address>
show pim static_rp
show pim rpset
create pim register_checksum_include_data rp_address <ipaddr>
delete pim register_checksum_include_data rp_address <ipaddr>
show pim register_checksum_include_data_rp_list
config pim-ssm {state [enable | disable] | group_range [default | <network_address>]}
show pim-ssm
62.1. config pim
 Description
This command is used to configure the PIM settings.
 Format
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> |
state [enable | disable] | mode [dm | sm | sm-dm] | dr_priority <uint 0-4294967294>} |
register_probe_time <value 1-127> | register_suppression_time <value 3-255>]
 Parameters
ipif Specifies the IP interface name.
<ipif_name 12>
Enter the IP interface name used here. This name can be up to 12 characters long.
all Specifies that all the IP interfaces will be used.
hello (Optional) Specifies the time between issuing hello packets to find neighboring routers.
<sec 1-18724>
Enter the hello time value here. This value must be between 1 and 18724 seconds.
The default value is 30 seconds.
jp_interval
(Optional) Specifies the interval between transmitting (flooding to all interfaces)
multicast messages to downstream routers, and automatically 'pruning' a branch from
the multicast delivery tree. This interval also determines the time interval the router uses
to automatically remove prune information from a branch of a multicast delivery tree and
begin to flood multicast messages to all branches of that delivery tree. These two actions
are equivalent. The default is 60 seconds.
<sec 1-18724>
Enter the join/prune interval value here. This value must be between 1 and 18724
seconds.
62. Protocol Independent Multicast (PIM) Commands
703