Panasonic ZEQUO 6400 Operating Instructions Manual page 958

ipif Specifies the IP interface used for this configuration.
<ipif_name 12>
Enter the IP interface name used here. This name can be up to 12 characters long.
ipaddress
Specifies the virtual router's IP address used.
<ipaddr>
Enter the virtual router's IP address used here.
state (Optional)Specifies the state of the virtual router function.
enable
Specifies that the virtual router function will be enabled.
disable
Specifies that the virtual router function will be disabled.
priority (Optional) Specifies the priority to be used for the Virtual Router Master election process
<int 1-254>
Enter the priority value used here. This value must be between 1 and 254.
advertisement_interval
(Optional) Specifies the time interval used between sending advertisement messages.
<int 1-255>
Enter the advertisement interval value here. This value must be between 1 and 255
seconds.
preempt (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within
the same VRRP group. Default is settings is true.
true Specifies that if the backup router's priority is set higher than the masters priority, it
will become the master instead of the current one.
false Specifies that if the backup router's priority is higher than the masters priority, it will
not become the master until the master failed.
critical_ip
(Optional) Specifies an IP address that will provide the most direct route to the Internet or
other critical network connections from this virtual router. This IP address must be a real
IP address of a real device on the network. If the connection from the virtual router to this
IP address fails, the virtual router will automatically be disabled. A new Master will be
elected from the backup routers participating in the VRRP group. Different critical IP
addresses may be assigned to different routers participating in the VRRP group and can
therefore define multiple routes to the Internet or other critical network connections.
<ipaddr>
Enter the critical interface's IP address used here.
critical_ip_state
(Optional) Specifies the state of checking the status (active or inactive) of a critical IP
address.
enable
Specifies that the critical IP state checking will be enabled.
disable
Specifies that the critical IP state checking will be disabled.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create a VRRP entry:
85. Virtual Router Redundancy Protocol (VRRP) Command List
959