Panasonic ZEQUO 6400 Operating Instructions Manual page 323

26. DHCPv6 Server Commands
26.4. config dhcpv6 pool ipv6network_addr
 Description
This command is used to configure the range of IPv6 network addresses for the
DHCPv6 pool. The IPv6 addresses in the range are free to be assigned to any DHCPv6
client. When the DHCPv6 server receives a request from the client, the server will
automatically find an available pool to allocate an IPv6 address.
The begin_networkaddr and end_networkaddr must observer some rules as
followed:
The prefix of the begin_networkaddr and end_networkaddr are not consistence,
otherwise, the Switching Hub will print an error message: The prefix of
begin_networkaddr
begin_networkaddr is 2000::1/64, and the end_networkaddr is 3000::100/64)
The begin address must not be large than end address, otherwise, the Switching Hub
will print an error message: The begin IPv6 address must be lower than or equal to
the end IPv6 address.(e.g.: the begin_networkaddr is 2000::200/64, and the
end_networkaddr is 2000::100/64)
There must not be intersection between the IPv6 address ranges of two pools,
otherwise, the Switch will print an error message: IPv6network address collision. (e.g.:
pool1: 2000::1/64 --- 2000::100/64, pool2: 2000::50/64 --- 2000::200/64)
The IPv6 network address can't be Link-local address and Multicast address,
otherwise, the Switch will print an error message: "The IPv6 network address can't be
Link-local address or Multicast address. " (e.g.:: pool1: FE80::1/64 --- FE80::100/64,
pool2: FE80::200/64 --- FE80::300/64
 Format
config dhcpv6 pool ipv6network_addr <pool_name 12> begin <ipv6networkaddr> end
<ipv6networkaddr>
 Parameters
<pool_name 12>
Enter the DHCPv6 pool name used here. This name can be up to 12 characters long.
begin Specifies the beginning IPv6 network address of the DHCPv6 pool.
<ipv6networkaddr>
Enter the beginning IPv6 network address of the DHCPv6 pool here.
end Specifies the ending IPv6 network address of the DHCPv6 pool.
<ipv6networkaddr>
Enter the ending IPv6 network address of the DHCPv6 pool here.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
and end_networkaddr
324
must be consistence.(e.g.: the