Panasonic ZEQUO 6400 Operating Instructions Manual page 697

61. Packet Storm Commands
countdown
The timer for shutdown mode. When a port enters a shutdown RX state, and if this times
out, the port will shut down the port forever. The default is 0 minutes.
<min 0>
Zero is the disable forever state.
<min 3-30>
Enter a value between 3 and 30 minutes.
disable
Specifies that when the action is shutdown and the countdown is disabled, when
the Switch detects a storm, it will shutdown the port directly.
time_interval
The sampling interval of received packet counts. This parameter is meaningless for
dropping packets is selected as action.
<value 5-600>
Specify the value between 5 and 600.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure traffic control and state:
Zxxx0:admin#config traffic control 1-10 broadcast enable action shutdown threshold
640 time_interval 10
Command: config traffic control 1-10 broadcast enable action shutdown threshold 640
time_interval 10
Success.
Zxxx0:admin#
61.2. config traffic control auto_recover_time
 Description
This command is used to configure the traffic auto recover time that allowed for a port to
recover from shutdown forever status. The time allowed for auto recovery from shutdown
for a port. The default value is 0, so no auto recovery is possible; the port remains in
shutdown forever mode. This requires manual entry of the CLI command "config ports [
<portlist> | all ] state enable" to return the port to a forwarding state. The default value is
0, which means disable auto recover mode, shutdown forever.
 Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
698