Panasonic ZEQUO 6400 Operating Instructions Manual page 384

To configure the filter DHCP server state:
Zxxx0:admin#config filter dhcp_server ports 1-10 state enable
Command: config filter dhcp_server ports 1-10 state enable
Success.
Zxxx0:admin#
32.2. show filter dhcp_server
 Description
This command is used to display the DHCP server/client filter list created on the
Switching Hub.
 Format
show filter dhcp_server
 Parameters
None.
 Restrictions
None.
 Example
To display the DHCP server/client filter list created on the Switching Hub:
Zxxx0:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports: 1,28
Trap & Log State: Enabled
Illegal Server Log Suppress Duration: 1 minutes
Permit DHCP Server/Client Table
Server IP Address Client MAC Address
----------------- ------------------- ---------------
Total Entries: 0
Zxxx0:admin#
Port
385
32. Filter Commands