Bootup Function Commands - Panasonic ZEQUO 6400 Operating Instructions Manual

13.Bootup Function Commands

show boot_file
config boot_up command
13.1. show boot_file
 Description
Use this command to show the boot file.
st
1. 1 Bootup Firmware/Configuration cannot be changed forever.
nd
2. The 2 Bootup Firmware can be set by command "config firmware image
<pathname> boot_up". The 2
"config configuration <pathname> boot_up".
3. Actual Bootup Firmware/Configuration is shown the current actual boot up
firmware and configuration.
4. If don't input <pathname> for save command, the configuration will be saved to
nd
the 2 Bootup Configuration path and if this path is not exist, the save command
will be fail and print prompt message.
 Format
show boot_file
 Parameters
None.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
13. Bootup Function Commands
nd
Bootup Configuration can be set by command
171