Panasonic ZEQUO 6400 Operating Instructions Manual page 274

22.7. config dhcp_relay option_60 state
 Description
This command is used to decide whether DHCP relay will process the DHCP Option 60 or
not. When Option 60 is enabled, if the packet does not have Option 60, then the relay
servers cannot be determined based on Option 60. The relay servers will be determined
based on either Option 61 or per IPIF configured servers.
 Format
config dhcp_relay option_60 state [enable | disable]
 Parameters
enable Specify to enable the DHCP relay function to use option 60 rules to relay DHCP packets.
disable Specify to disable the DHCP relay function from using option 60 rules to relay DHCP
packets.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the DHCP Option 60 state:
Zxxx0:admin#config dhcp_relay option_60 state enable
Command: config dhcp_relay option_60 state enable
Success.
Zxxx0:admin#
22. DHCP Relay Commands
275