Panasonic ZEQUO 6400 Operating Instructions Manual page 678

60.7. config ospfv3 area
 Description
This command is used to configure an OSPFv3 area. The backbone area (0.0.0.0) can not
be configured to be stub area.
 Format
config ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
 Parameters
<area_id>Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 area in the OSPFv3 domain.
type Specifies the OSPFv3 area mode of operation. There are two types:
normal
Specifies that the OSPFv3 area will be configured as a normal area.
stub Specifies that the OSPFv3 area will be configured as a stub area.
stub_summary
(Optional) Specifies the OSPFv3 stub area to import inter-area prefix LSA
advertisements or not.
enable
disable
metric
(Optional) Specifies the default cost of OSPFv3 stub area.
<value 0-65535>
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create OSPFv3 areas:
Zxxx0:admin# config ospfv3 area 2.2.2.2 type normal
Command: config ospfv3 area 2.2.2.2 type normal
Success.
Zxxx0:admin#
Import inter-area prefix LSA into this stub area.
Do not import inter-area prefix LSA into this stub area.
Enter the metric value used here. This value must be between 0 and
65535. The default value is 1.
679
60. OSPFv3 Commands