Panasonic ZEQUO 6400 Operating Instructions Manual page 512

46.11. config lldp_med notification
topo_change ports
 Description
This command is used to enable or disable each port for sending topology change
notification to configured SNMP trap receiver(s) if an endpoint device is removed or
moved to another port. The default state is disabled.
 Format
config lldp_med notification topo_change ports [<portlist> | all] state [enable |
disable]
 Parameters
<portlist>Specify a range of ports to be configured.
all Specify to set all ports in the system.
state Enable or disable the SNMP trap notification of topology change detected state.
enable Enable the SNMP trap notification of topology change detected.
disable Disable the SNMP trap notification of topology change detected. The default
notification state is disabled.
 Restrictions
Only Administrator and Operator-level users can issue this command.
 Example
To enable topology change notification on ports 1 to 2:
Zxxx0:admin#config lldp_med notification topo_change ports 1-2 state enable
Command: config lldp_med notification topo_change ports 1-2 state enable
Success.
Zxxx0:admin#
513
46. LLDP Commands