Panasonic ZEQUO 6400 Operating Instructions Manual page 648

 Example
To configure OSPF interface settings:
Zxxx0:admin# config ospf ipif System priority 2 hello_interval 20 metric 2 state
enabled
Command: config ospf ipif System priority 2 hello_interval 20 metric 2 state
enabled
Success.
Zxxx0:admin#
59.2. create ospf aggregation
 Description
This command is used to create an OSPF area aggregation entry.
 Format
create ospf aggregation <area_id> <network_address> lsdb_type [summary {advertise
[enable | disable]} | nssa_ext {advertise [enable | disable]}]
 Parameters
<area_id>
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the
OSPF area in the OSPF domain.
<network_address>
The IP address that uniquely identifies the network that corresponds to the OSPF Area.
The network address format is 'IP address/prefix length'.
lsdb_type
Specifies the Link-State Database (LSDB) type of address aggregation.
summary
Specifies the LSDB type as summary.
advertise
(Optional) Allows for the advertisement of the summary LSDB.
enable
disable
nssa_ext
Specifies the the LSDB type as a Not-So-Stub Area External Route (NSSA EXT).
advertise
(Optional) Allows for the advertisement of aggregated NSSA external route.
enable
disable
59. Open Shortest Path First (OSPF) Command List
Specifies that the advertisement trigger will be enabled.
Specifies that the advertisement trigger will be disabled.
Specifies that the advertisement trigger will be enabled.
Specifies that the advertisement trigger will be disabled.
649