Panasonic ZEQUO 6400 Operating Instructions Manual page 715

62. Protocol Independent Multicast (PIM) Commands
Zxxx0:admin# show pim ipmroute
Command: show pim ipmroute
PIM IP Multicast Route Table
UA = Upstream AssertTimer
AM = Assert Metric
AMPref = Assert MetricPref
ARB = Assert RPTBit
Group Address Source Address
---------------- ----------------- ---- ---- ------ ---- ---- ------- ----
225.0.0.0 12.90.90.90/32
225.0.0.1 12.90.90.90/32
225.0.0.5 12.90.90.90/32
225.7.7.5 12.90.90.90/32
226.0.0.0 12.90.90.90/32
227.0.0.3 12.90.90.90/32
232.0.0.0 12.90.90.114/32
239.255.255.250 12.90.90.90/32
Total Entries: 8
Zxxx0:admin#
62.14. create pim static_rp group
 Description
This command is used to create a static RP.
 Format
create pim static_rp group <network_address> rp <ipaddr>
 Parameters
group Specifies to assign the multicast group address for this static RP.
<network_address>
Enter the multicast group address used here.
rp Specifies the IP address used by this static RP.
<ipaddr>
Enter the IP address used here.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
UA AM AMPref ARB
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
716
Flag Type Mode
RPT (*.G) ASM
RPT (*.G) ASM
RPT (*.G) ASM
RPT (*.G) ASM
RPT (*.G) ASM
RPT (*.G) ASM
SPT (S.G) SSM
RPT (*.G) ASM