Panasonic ZEQUO 6400 Operating Instructions Manual page 680

60.9. create ospfv3 aggregation
 Description
This command is used to create an OSPFv3 area aggregation.
 Format
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
 Parameters
<area_id>Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 area in the OSPFv3 domain.
<ipv6networkaddr>
Specifies the IPv6 network address of the aggregation.
advertiseSpecifies whether the OSPFv3 ABR will use this aggregation to aggregate the intra-area
routes or not.
enable
Specifies that the OSPFv3 ABR will use this aggregation to aggregate the intra-area
routes when it advertises these routes to another area.
disable
Specifies that the OSPFv3 ABR will not use this aggregation to aggregate the intra-
area routes when it advertises these routes to another area.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create an OSPFv3 area aggregation:
Zxxx0:admin# create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Command: create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Success.
Zxxx0:admin#
681
60. OSPFv3 Commands