Panasonic ZEQUO 6400 Operating Instructions Manual page 737

63. PIM for IPv6 Command List
63.14. show pim6 mroute s_g
 Description
This command is used to display the multicast routing information for (S, G) or (S, G, rpt)
entries generated by PIM6.
 Format
show pim6 mroute s_g {rpt} {group <ipv6addr> source <ipv6addr> {ipif <ipif_name 12>}}
 Parameters
rpt (Optional) Specify the (S, G, rpt) entry.
group (Optional) Specify the IPv6 multicast group address to be displayed.
<ipv6addr>
Enter the IPv6 address.
source (Optional) Specify the IPv6 source address to be displayed.
<ipv6addr>
Enter the IPv6 address.
ipif (Optional) Specify to the IPv6 interface name to be displayed.
<ipif_name 12>
Enter the IPv6 interface name.
 Restrictions
None.
 Example
To show all (S, G) route entries generated on the Switch:
Zxxx0:admin#show pim6 mroute s_g
Command: show pim6 mroute s_g
(S, G) Entry Table
------------------------
Group : FF13::100
Source : 2001::1111
Group : FF13::100
Source : 2001::2222
Group : FF13::200
Source : 2001::1111
Group : FF13::300
Source : 2001::1111
Total Entries: 4
Zxxx0:admin#
738