Panasonic ZEQUO 6400 Operating Instructions Manual page 145

9. ARP Commands
 Parameters
state Enable or disable the ARP refresh. The default is enable.
enable
Enable the ARP refresh.
disable
Disable the ARP refresh.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To disable the ARP refresh state:
Zxxx0:admin#config arp refresh time_out state disable
Command: config arp refresh time_out state disable
Success.
Zxxx0:admin#
9.5. config arp_aging time
 Description
This command is used to set the maximum amount of time, in minutes, that an ARP
entry can remain in the Switching Hub
is dropped from the table.
 Format
config arp_aging time <min 0-65535>
 Parameters
<min 0-65535>
The ARP age-out time, in minutes. The default is 20 minutes. The range is 0 to 65535
minutes.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
s ARP table, without being accessed, before it
'
146