Table of Contents
Advertisement
67. Precision Time Protocol (PTP) Commands
delay_req_interval
(Optional) Specifies the permitted mean time interval between successive delay request
messages which are sent by a slave to a specific port on the master. This mean time
interval value is determined and advertised by a master.
<value 0-5>
Enter the delay required interval value used here. This value must be between 0
and 5.
pdelay_req_interval
(Optional) Specifies the permitted mean time interval between successive pdelay_request
messages.
<sec 1-32>
Enter the permitted mean time interval value used here. This value must be
between 1 and 32 seconds.
delay_mechanism
(Optional) Specifies the mechanism for measuring the propagation delay time of an event
message.
e2e
E2E indicates that the port is configured to use the delay request-response
mechanism.
p2p
P2P indicates that the port is configured to use the peer delay mechanism.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the announce interval attribute of ports 1-4 to 3 seconds:
Zxxx0:admin# config ptp boundary ports 1:1-1:4 announce interval 3
Command: config ptp boundary ports 1:1-1:4 announce interval 3
The announce interval is automatically adjusted to 4.
Success.
Zxxx0:admin#
To configure the announce timeout attribute of ports 1-4 to 4 seconds, which is about
4*Announce interval:
Zxxx0:admin# config ptp boundary ports 1:1-1:4 announce timeout 4
Command: config ptp boundary ports 1:1-1:4 announce timeout 4
Success.
Zxxx0:admin#
To configure the sync_interval attribute of the all the PTP ports to 2 seconds:
772
Advertisement
Chapters
Table of Contents
