System Severity Commands - Panasonic ZEQUO 6400 Operating Instructions Manual

80. System Severity Commands

80.System Severity Commands
The commands are used to configure the significance level of events,
such as trapping or logging, in trap and log management using SNMP
(Simple Network Management Protocol).
config system_severity [trap | log | all] [emergency | alert | critical | error | warning | notice |
information | debug | <level 0-7>]
show system_severity
80.1. config system_severity
 Description
This command is used to configure severity level control for the system.
 Format
config system_severity [trap | log | all] [emergency | alert | critical | error | warning |
notice | information | debug | <level 0-7>]
 Parameters
trap Configure severity level control for a trap.
log Configure severity level control for a log.
all Configure severity level control for a trap and a log.
emergency
Specify to configure the severity level for emergency messages.
alert Specify to configure the severity level for alert messages.
critical Specify to configure the severity level for critical messages.
error Specify to configure the severity level for error messages.
warning Specify to configure the severity level for warning messages.
notice Specify to configure the severity level for notice messages.
informational
Specify to configure the severity level for informational messages.
debug Specify to configure the severity level for debug messages.
<level 0-7>
Specify to configure a severity level between 0 and 7.
 Restrictions
Only Administrator and Operator-level users can issue this command.
912