Panasonic ZEQUO 6400 Operating Instructions Manual page 537

49. MAC-based Access Control Commands
 Parameters
<portlist>When a port is configured as gurest VLAN member port, this port will move to guest
VLAN if it's MAC-based access control state is enable.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the MAC-based access control guest VLAN membership for port 1 to 8:
Zxxx0:admin# config mac_based_access_control guest_vlan ports 1-8
Command: config mac_based_access_control guest_vlan ports 1-8
Success.
Zxxx0:admin#
49.6. config mac_based_access_control ports
 Description
This command is used to configure the MAC-based access control setting. When the
MAC-based access control function is enabled for a port, and the port is not a MAC-
based access control guest VLAN member, the user who is attached to this port will
not be forwarded unless the user passes the authentication. A user that does not pass
the authentication will not be serviced by the Switching Hub. If the user passes the
authentication, the user will be able to forward traffic operated under the assigned
VLAN.
When the MAC-based access control function is enabled for a port, and the port is a
MAC-based access control guest VLAN member, the port(s) will be removed from the
original VLAN(s) member ports, and added to MAC-based access control guest VLAN
member ports. Before the authentication process starts, the user is able to forward
traffic under the guest VLAN. After the authentication process, the user will be able
to access the assigned VLAN.
If the port authorize mode is port based mode, when the port has been moved to the
authorized VLAN, the subsequent users will not be authenticated again. They will
operate in the current authorized VLAN. If the port authorize mode is host based
mode, then each user will be authorized individually and be capable of getting its
own assigned VLAN.
 Format
config mac_based_access_control ports [<portlist> | all] {state [enable | disable] |
aging_time [infinite | <min 1-1440>] | block_time <sec 0-300> | max_users [<value 1-
4000> | no_limit]}(1)
538