Panasonic ZEQUO 6400 Operating Instructions Manual page 984

To delete ports 4 through 8 from VLAN 1:
Zxxx0:admin#config vlan vlanid 1 delete 4-8
Command: config vlan vlanid 1 delete 4-8
Success.
Zxxx0:admin#
To enable the VLAN default advertisement:
Zxxx0:admin#config vlan vlanid default advertisement enable
Command: config vlan vlanid default advertisement enable
Success.
Zxxx0:admin#
87.7. config port_vlan
 Description
This command is used to set the ingress checking status and the sending and receiving of
GVRP information.
 Format
config port_vlan [<portlist> | all] {gvrp_state [enable | disable] | ingress_checking [enable |
disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1- 4094>} (1)
 Parameters
<portlist>Specify a range of ports to be configured.
all Specify to configure all ports.
gvrp_state
Specify if the port is allowed to dynamically become a member of a VLAN when receiving
GVRP.
enable
Enable GVRP for the ports specified in the port list.
disable
Disable GVRP for the ports specified in the port list.
ingress_checking
When ingress checking is enabled, the Switch checks if the incoming packet was assigned
a VLAN on which the ingress port is a VLAN member. If the incoming packet and the
ingress port are not in the same VLAN, the packet will be dropped.
enable
Enable ingress checking for the specified port list.
disable
Disable ingress checking for the specified port list.
985
87. VLAN Commands