22. DHCP Relay Commands
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP destination address from the Switching Hub's DHCP relay table:
Zxxx0:admin#config dhcp_relay delete ipif System 10.43.21.12
Command: config dhcp_relay delete ipif System 10.43.21.12
Success.
Zxxx0:admin#
22.4. config dhcp_relay option_60 add string
Description
This command is used to configure the Option 60 relay rules. Note that different strings
can be specified with the same relay server, and the same string can be specified with
multiple relay servers. The system will relay the packet to all the matching servers.
Format
config dhcp_relay option_60 add string <multiword 255> relay <ipaddr> [exact-match |
partial-match]
Parameters
<multiword 255>
Specify a string.
relay
Specify a relay server IP address.
<ipaddr>
Enter the IP address here.
exact-match
The Option 60 string in the packet must fully match the specified string.
partial-match
The Option 60 string in the packet only need partially match the specified string.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure DHCP Option 60 to decide to relay which DHCP server:
272