Panasonic ZEQUO 6400 Operating Instructions Manual page 638

ipaddress
Specify the IPv4 address or IPv6 address of the host.
<ipaddr>
Specify the IPv4 address of the host.
<ipv6addr>
Specify the IPv6 address of the host.
severity (Optional) Specify the severity level supported: emergency, alert, critical, error, warning,
notice, informational, or debug.
emergency
Specify emergency messages.
alert Specify alert messages.
critical
Specify critical messages.
error Specify error messages.
warning
Specify warning messages.
noticeSpecify notice messages.
informational
Specify informational messages.
debugSpecify debug messages.
<level 0-7>
Specify a level between 0 and 7.
facility Some of the operating system daemons and processes have been assigned facility values.
Processes and daemons that have not been explicitly assigned a facility may use any of
the"local use" facilities or they may use the "user-level" facility. Those facilities that have
been designated are shown in the following:
local0 User-defined facility.
local1 User-defined facility.
local2 User-defined facility.
local3 User-defined facility.
local4 User-defined facility.
local5 User-defined facility.
local6 User-defined facility.
local7 User-defined facility.
udp_port
Specify the UDP port number.
<udp_port_number>
Specify the UDP port number.
state The syslog protocol has been used for the transmission of event notification messages
across networks to host. This option enables or disables the host to receive such
messages.
enable
Enable the host to receive messages.
disable
Disable the host to receive messages.
 Restrictions
Only Administrator and Operator-level users can issue this command.
 Example
To create a new syslog host:
58. Network Monitoring Commands
639