Panasonic ZEQUO 6400 Operating Instructions Manual page 443

38. IP Routing Commands
 Example
To disable the OSPF ECMP function:
Zxxx0:admin# disable ecmp ospf
Command: disable ecmp ospf
Success.
Zxxx0:admin#
38.9. config ecmp algorithm
 Description
This command is used to configure the ECMP route load-balancing algorithm.
 Format
config ecmp algorithm {ip_destination | [ip_source| crc_low | crc_high] |
tcp_udp_port}
 Parameters
ip_destination
(Optional) Specifies that the ECMP algorithm will include the destination IP. It is set by
default.
ip_source
(Optional) Specifies that the ECMP algorithm will include the lower 5 bits of the source IP.
This attribution is mutually exclusive with crc_low and crc_high. If it is set, crc_low and
crc_high will be excluded. It is not set by default.
crc_low (Optional) Specifies that the ECMP algorithm will include the lower 5 bits of the CRC. This
attribution is mutually exclusive with crc_high and ip_source. If it is set, crc_high and
ip_source will be excluded. It it set by default.
crc_high (Optional) Specifies that the ECMP algorithm will include the upper 5 bits of the CRC. This
attribution is mutually exclusive with ip_source and crc_low. If it is set, crc_low and
ip_source will be excluded. It is not set by default.
tcp_udp_port
(Optional) Specifies that the ECMP algorithm will include the TCP or UDP port. It is not set
by default.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To set the ECMP hash algorithm:
444