Panasonic ZEQUO 6400 Operating Instructions Manual page 890

Zxxx0:admin# show stack_device
Command: show stack_device
Box ID Box Type
------- ---------------
1 Zxxx0
2 Zxxx0
Zxxx0:admin#
76.6. config box_id current_box_id
 Description
This command configures the box ID. By default, the box ID is automatically assigned
by the system based topology election results. Administrators can assign box IDs
statically. The new box ID will take effect after unit reboot. Each unit in the Switch
stack must have a unique box IDs. If the IDs duplicate, the stack system cannot stack
normally.
 Format
config box_id current_box_id <value 1-4> new_box_id [auto | <value 1-4>]
 Parameters
<value 1-3>Enter the current box ID value used here. This value must be between 1 and 4.
new_box_id
Specifies the new ID assigned to the box.
auto Specifies that the box ID to be assigned automatically by the stack system. The
new box ID will take effect after the next boot.
<value 1-4>
Enter the new box ID used here. This value must be between 1 and 4.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure box ID of box 1 to be auto:
Zxxx0:admin# config box_id current_box_id 1 new_box_id auto
Command: config box_id current_box_id 1 new_box_id auto
Success.
Zxxx0:admin#
H/W Version Serial Number
------------ ----------------
A1
A1
891
76. Stacking Commands