Panasonic ZEQUO 6400 Operating Instructions Manual page 492

 Example
To delete a link aggregation group:
Zxxx0:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
Zxxx0:admin#
45.3. config link_aggregation group_id
 Description
This command allows you to configure a link aggregation group that was created
with the create link_aggregation command above.
 Format
config link_aggregation group_id <value 1-48> {master_port <port> | ports <portlist> |
state [enable | disable]} (1)
 Parameters
<value 1-48>
Specify the group ID. The group number identifies each of the groups. The Switching
Hub allows up to 48 link aggregation groups to be configured.
master_port
Specify which port (by port number) of the link aggregation group will be the master
port. All of the ports in a link aggregation group will share the port configuration with
the master port.
<port>
Specify the master port ID.
ports Specify a range of ports that will belong to the link aggregation group. The port list
should include the master port.
<portlist>
Specify a range of ports to be configured.
state Enable or disable the specified link aggregation group. If LACP group state is enabled,
the ports' state machine will start.
enable
Enable the specified link aggregation group.
disable
Disable the specified link aggregation group.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
45. Link Aggregation Commands
493