Alcatel-Lucent 7750 SR OS Service Manual page 392

Configuring a VPLS Service with CLI
SAP Auto Edge
The SAP
connected to another bridge.
If auto-edge is enabled, and STP concludes there is no bridge behind the SAP, the OPER_EDGE
variable will dynamically be set to true. If auto-edge is enabled, and a BPDU is received, the
OPER_EDGE variable will dynamically be set to true (see
Valid values for SAP auto-edge are enabled and disabled with enabled being the default.
CLI Syntax: config>service>vpls>sap>stp#
SAP Link Type
The SAP link-type parameter instructs STP on the maximum number of bridges behind this SAP.
If there is only a single bridge, transitioning to forwarding state will be based on handshaking (fast
transitions). If more than two bridges are connected via a shared media, their SAPs should all be
configured as shared, and timer-based transitions are used.
Valid values for SAP link-type are shared and pt-pt with pt-pt being the default.
CLI Syntax: config>service>vpls>sap>stp#
Page 392
command is used to instruct STP to dynamically decide whether the SAP is
edge-port
[no] auto-edge
Default: auto-edge
link-type {pt-pt|shared}
Default: link-type pt-pt
Restore Default: no link-type
SAP Edge Port on page
7750 SR OS Services Guide
391).