Configuring Command Switching For The Protection Group; Configuring The Psc Message Sending Interval; Displaying And Maintaining Mpls Protection Switching - HP MSR2000 Configuration Manual

Step
5. Configure the protection group
to use
switching.
Configuring command switching for the protection
group
Step
Enter system view.
1.
2. Enter the view of the tunnel
bundle
protection group.
3. Configure
action.

Configuring the PSC message sending interval

The two ends of a tunnel periodically send PSC messages to coordinate the protection state for
bidirectional path switching.
You can prevent PSC messages from occupying too much bandwidth and resources by modifying the
sending interval as needed.
To configure the PSC message sending interval:
Step
1. Enter system view.
2. Enter
switching view.
3. Configure the PSC message
sending interval.
Displaying and maintaining MPLS protection
switching
Execute display commands in any view and reset commands in user view.
Command
protection switching-mode
bidirectional path
bidirectional
Command
system-view
interface tunnel-bundle number
interface in the
[ protection { onetoone |
oneplusone } ]
a switching
protection switch { clear | force |
lock | manual }
Command
system-view
MPLS protection
mpls protection
psc message-interval interval
Remarks
N/A
N/A
By default, the sending interval is 5
seconds.
437
Remarks
This command can be configured
only on the tunnel bundle interface
in 1:1 protection switching mode.
By default, the protection group in
1:1 protection switching mode uses
unidirectional path switching.
1+1 protection switching mode
supports only bidirectional path
switching.
Remarks
N/A
It is not required to specify the
protection switching mode when
you enter the view of an existing
tunnel bundle interface.
By default, no switching action is
configured.