Initial Configuration; Configure Your Computer - HP PS110 Quick Start Manual

HP PS110 Wireless VPN Router Quickstart
2
1

Initial configuration

This procedure describes how to perform initial configuration for a factory-
default PS110. For illustration purposes, a simple scenario is used.
In this scenario, the PS110 links wired and wireless computers to the Internet
through a cable modem provided by an Internet Service Provider (ISP). For
instructions on how to configure other scenarios, see the HP PS110 Wireless
VPN Router Configuration/Administration Guide.
2
1
Simple scenario
1: Wired computer
2: AC/DC power adapter
3: PS110
Wall mounting
3
1: Wall anchors
2: Mounting screws
3: PS110 wall-mounting
slots
3
4
6
4: Cable modem
5: Internet
6: Wireless computer
4
The PS110 is managed through its web-based management interface using
Microsoft Internet Explorer 8 or later, Google Chrome v29 or later, or Mozilla
Firefox v24 or later.
You must perform the initial configuration from a computer that is directly
connected to one of the PS110 LAN ports. If you configure the PS110 from a
wireless computer, you might lose contact with the PS110 when you change the
wireless configuration.
Note: Do not power on the PS110 until directed.
A. Configure your computer
1.
Verify that the Ethernet network interface of your computer is set to
obtain an IP address automatically from DHCP.
2. Disable any wireless connection on your computer.
B. Connect cables and power on the PS110
1. Connect your cable modem to the WAN port on the PS110 using a
standard Ethernet cable.
2.
Connect the LAN port on your computer to one of the LAN ports on the
PS110 using a standard Ethernet cable.
3.
To be able to discover and monitor the health status of HP servers from
the PS110, connect a network cable between any available LAN port and
the server's iLO port.
Note: It is also possible to use a single cable between the PS110 and
5
4.
Connect other equipment to the LAN ports using standard Ethernet
cables.
5.
Ensure that the power button is not pressed in.
6. Connect the AC/DC power adapter to the power socket on the PS110,
and then plug the AC/DC power adapter into a standard electrical wall
socket.
7. Power on the PS110 by pressing the power button.
Initially, the PS110 LAN port LEDs turn on and off. Wait approximately
one minute until the Alert LED turns off before proceeding to the next
step.
server for data and iLO communications, but this requires that
you connect to server Ethernet port 1, and requires changes to
the server configuration to cause the server Ethernet 1 port to be
"shared" for data and iLO communications. See the server
documentation on shared iLO mode for more information.
Initial configuration