Maintenance And Service; Maintenance Schedule - Teledyne T200 User Manual

MAINTENANCE AND SERVICE

5.
Follow the maintenance schedule set forth in Section 5.1. Service and troubleshooting are
covered in Section 5.7.
ATTENTION

MAINTENANCE SCHEDULE

Table 5-1 shows a typical maintenance schedule.
In certain environments (e.g., dusty, very high ambient pollutant levels) some maintenance
procedures may need to be performed more often than shown.
Important
106 Teledyne API T200 NO/NO
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Avoid spraying anything directly onto any part of the analyzer.
WARNING – ELECTRICAL SHOCK HAZARD
Disconnect power before performing any of the following
operations that require entry into the interior of the analyzer.
CAUTION – QUALIFIED PERSONNEL
These maintenance procedures must be performed by
qualified technicians only.
IMPACT ON READINGS OR DATA
A span and zero calibration check (see CAL CHECK REQ'D
Column of Table 5-1) must be performed following some of the
maintenance procedures listed herein. To perform a CHECK of
the instrument's Zero or Span Calibration, refer to Sections
4.2.1.1 and 4.2.1.2, respectively.
DO NOT press the Zero or Span buttons at the end of each
operation (actual calibration), as this will reset the stored values
for OFFSET and SLOPE and alter the instrument's calibration.
Alternatively, use the Auto Cal feature described in Section 4.3
with the CALIBRATE attribute set to OFF (not enabled).
/NO Analyzer with NumaView™ Software
2 x
083730200A DCN7962