Rcommand Member; Rcommand Commander - Edge-Core ES4626 User Manual

Function: When this command is executed in the commander switch, the newly
discovered candidate switches will be added to the cluster as a member switch
automatically; the "no cluster auto-add enable" command disables this function.
Command mode: Global Mode
Default: This function is disabled by default. That means that the candidate switches are
not automatically added to the cluster.
Instructions: When this command is executed in the commander switch and the
commander switch receives the cluster register packets sent by the new switch, the
commander switch adds the candidate switch to the cluster. If this command is executed
in a non-commander switch, an error will be displayed.
Example: Enable the auto adding function in the commander switch.
Switch(config)#cluster auto-add enable

27.3.7 rcommand member

Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> is the cluster ID of the member switch, valid rang is 1 to 23.
Command mode: Admin Mode
Instructions: Enter the Admin Mode of the member switch and configure the member
switch remotely. Use "exit" to quit the configuration interface of the member switch. If this
command is executed in a non-commander switch, an error will be displayed.
Example: In the commander switch, enter the configuration interface of the member
switch with mem-id 15.
Switch#rcommand member 15

27.3.8 rcommand commander

Command: rcommand commander
Function: In the member switch, use this command to configure the commander switch.
Command mode: Admin Mode
Instructions: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The command "exit"
is used to quit the configuration interface of the commander switch. If this command is
executed in the commander switch, an error will be displayed.
Example: In the member switch, enter the configuration interface of the commander
switch.
910