Commands For Urpf - Edge-Core ES4626 User Manual

debug urpf
no debug urpf
show urpf
show urpf interface

10.4.4 Commands For URPF

10.4.4.1 urpf enable
Command: urpf enable
no urpf enable
Function: Enable URPF on layer 3 interface, the "no" form of this command disables the
URPF enabled on this interface
Command Mode: Interface Mode
Default: URPF protocol not enabled by system default
Example: Enable urpf on interface vlan2
Switch(Config)#interface vlan 2
Switch(Config-if-Vlan1)#urpf enable
10.4.4.2 show urpf
Command: show urpf
Function: Display which interfaces have been enabled with urpf function
Command Mode: Admin mode
Example:
Switch#show urpf
Vlan2 enable urpf
10.4.4.3 show urpf interface
Command: show urpf interface {ethernet | port-channel|vlan} ifname
Function: Display the urpf rule generated on certain port (interface).
Parameter: Port name or interface name
Command Mode: Admin Mode
Example: Display the urpf rule generated under vlan2
Enable the debugging information of the
URPF module, the "no" form of this
command disables the URPF debugging
information output
Display which layer 3 interfaces has
enabled with URPF
Display the URPF rules generated by
the interface or layer 2 interface
320