Setting The Switch's Ip Address (Ip Version 4) - Edge-Core ECS3510-26P Management Manual

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Installation manual (50 pages)

Table of Contents

Use the System > IP page to configure an IPv4 address for management

access over the network. This switch supports both IPv4 and IPv6, and can

be managed through either of these address types. For information on

configuring the switch with an IPv6 address, see

Address (IP Version 6)" on page

You can direct the device to obtain an address from a BOOTP or DHCP

server, or manually configure a static IP address. Valid IP addresses consist

of four decimal numbers, 0 to 255, separated by periods. Anything other

than this format will not be accepted.

To configure an address compatible with your network, you may need to

change the switch's default settings. You may also need to a establish a

default gateway between the switch and management stations that exist

on another network segment.

"DHCP Client" on page 955

"Basic IPv4 Configuration" on page 962

These parameters are displayed:

Management VLAN – ID of the configured VLAN (1-4093). By default,

all ports on the switch are members of VLAN 1. However, the

management station can be attached to a port belonging to any VLAN,

as long as that VLAN has been assigned an IP address.

IP Address Mode – Specifies whether IP functionality is enabled via

manual configuration (Static), Dynamic Host Configuration Protocol

(DHCP), or Boot Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will

not function until a reply has been received from the server. Requests

will be broadcast periodically by the switch for an IP address. DHCP/

BOOTP responses can include the IP address, subnet mask, and default

gateway. (Default: DHCP)

IP Address – Address of the VLAN to which the management station is

attached. Valid IP addresses consist of four numbers, 0 to 255,

separated by periods. (Default: None)

Subnet Mask – This mask identifies the host address bits used for

routing to specific subnets. (Default: None)

Gateway IP Address – IP address of the gateway router between the

switch and management stations that exist on other network

segments. (Default: 0.0.0.0)

MAC Address – The physical layer address for this switch.

Restart DHCP – Requests a new IP address from the DHCP server.