1000BASE-T/SFP Ports
These are combination Gigabit RJ-45 ports with shared Small Form Factor
Pluggable (SFP) transceiver slots. If an SFP transceiver (purchased separately) is
installed in a slot and has a valid link on the port, the associated RJ-45 port is
disabled.
The 1000BASE-T RJ-45 ports support automatic MDI/MDI-X operation, so you can
use straight-through cables for all network connections to PCs or servers, or to other
switches or hubs. (See "1000BASE-T Pin Assignments" on page B-3.)
Port and System Status LEDs
The ES3526XA includes a display panel for key system and port indications that
simplify installation and network troubleshooting. The LEDs, which are located on
the front panel for easy viewing, are shown below and described in the following
tables.
1
LED
Condition
Fast Ethernet Ports (Ports 1-24)
(Link/Activity)
On/Flashing
Amber
On/Flashing
Green
Off
Gigabit Ethernet Ports (Ports 25-26)
(Link/Activity)
On/Flashing
Amber
On/Flashing
Green
Off
Port Status LEDs
2
3
4
5
6
Figure 1-2 Port LEDs
Table 1-1 Port Status LEDs
Status
Port has established a valid 10 Mbps network connection.
Flashing indicates activity.
Port has established a valid 100 Mbps network connection.
Flashing indicates activity.
There is no valid link on the port.
Port has established a valid 10/100 Mbps network connection.
Flashing indicates activity.
Port has established a valid 1000 Mbps network connection.
Flashing indicates activity.
There is no valid link on the port.
Description of Hardware
8
9
10
11
7
12
1
1-3