Outputs For Signalling - ABB REG650 Technical Manual

Section 18
IED physical connections
18.3.2
588
Terminal Description
X326-4
X326-5 Power output 3, normally open
X326-6
Table 468: Output contacts X331, 3U full 19"
Terminal Description
X331-1 Power output 1, normally open
X331-2
X331-3 Power output 2, normally open
X331-4
X331-5 Power output 3, normally open
X331-6
Table 469: Output contacts X336, 3U full 19"
Terminal Description
X336-1 Power output 1, normally open
X336-2
X336-3 Power output 2, normally open
X336-4
X336-5 Power output 3, normally open
X336-6

Outputs for signalling

Signal output contacts are used for signalling on starting and tripping of the IED. On
delivery from the factory, the pickup and alarm signals from all the protection stages
are routed to signalling outputs. See connection diagrams.
Each signal connector terminal is connected with one 14 or 16 Gauge wire.
1MRK 502 043-UUS B
PCM600 info
Hardware module Hardware channel
instance
BIO_4 BO3_PO
PCM600 info
Hardware module Hardware channel
instance
BIO_5 BO1_PO
BIO_5 BO2_PO
BIO_5 BO3_PO
PCM600 info
Hardware module Hardware channel
instance
BIO_6 BO1_PO
BIO_6 BO2_PO
BIO_6 BO3_PO
Technical Manual