ABB REG650 Technical Manual page 330

Section 12
Control
324
If both sides are higher than the set values, the measured values are compared with the
set values for acceptable frequency, phase angle and voltage difference: FreqDiff,
PhaseDiffand VDiffSC. If a compensation factor is set due to the use of different
voltages on the bus and line, the factor is deducted from the line voltage before the
comparison of the phase angle values.
The frequency on both sides of the circuit breaker is also measured. The frequencies
must not deviate from the rated frequency more than +/-5Hz.
Two sets of settings for frequency difference and phase angle difference are available
and used for the manual closing and autoreclose functions respectively, as required.
The inputs BLOCK and BLKSC are available for total block of the complete
SESRSYN (25) function and block of the Synchronism check function respectively.
Input TSTSC will allow testing of the function where the fulfilled conditions are
connected to a separate test output.
The outputs MANSYOK and AUTOSYOK are activated when the actual measured
conditions match the set conditions for the respective output. The output signal can be
delayed independently for MANSYOK and AUTOSYOK conditions.
A number of outputs are available as information about fulfilled checking conditions.
VOKSC shows that the voltages are high, VDIFFSC, FRDIFFA, FRDIFFM,
PHDIFFA, PHDIFFM shows when the voltage difference, frequency difference and
phase angle difference conditions are out of limits.
Output INADVCLS, inadvertent circuit breaker closing, indicate that the circuit
breaker has been closed by some other equipment or function than SESRSYN. The
output is activated, if the voltage condition is fulfilled at the same time the phase angle
difference between bus and line is suddenly changed from being larger than 60 degrees
to smaller than 5 degrees.
1MRK 502 043-UUS B
Technical Manual